P1S Sliding Spool Holder Upgrade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A way to remove or load the spool from the back of the printer only by moving it up or down.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 17
- Makes
- 0
- Views
- 329
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- GNU General Public License v3.0
An easy upgrade for your P1S!
Instead of moving the spool backwards to remove it, slide it up.
Helpful if you want to place your printer against a wall.
NOTE: one M3x10 and two M3x6 screws are needed.
Remove the metal spool holder from the back of the printer, then remove the top-right (right on top of the spool holder screw) back panel screw. Use the 3 M3x10 screws (one acquired by you, the other two from the spool holder) to secure the first half of the new spool holder to the printer. Then use the two M3x6 to secure the metal spool holder to the second half. Then push the PTFE tube a bit further into the printer, so that the two halves can slide without any other collisions. Slide them together, and you have a new way of accessing your spools!
* Should also fit the X1/X1C and P1P (not tested)
* The one shown in the photos is an older version, which didn't have the small handle for easier removal.