Aqara Door & Window Sensor Trim Shim
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Does your door have trim that makes in impossible to use a smart door sensor?! I have the parametric solution for you!
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 25
- Makes
- 0
- Views
- 152
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
This model is for the Aqara Door & Window Sensor (affiliate link), and helps you level the two pieces inline with any door or window trim.
My door has a ½ inch trim that frames it, and makes it not possible to keep the two pieces of the sensor flush making them not work well.
I needed a model that would raise the sensor inline with the trim so that both mate up well.
If your trim is different then ½ inch, update the model with the .f3d file included. All you need to do is update the parameter SH to your height in mm.
In Fusion 360 → Open Model → “Modify” Drop Down → “Change Parameters” → Update “SH” to Desired Height → Click “OK”
Printer settings:
- .2mm height
- .4 Nozzle
- 10% infill
- PLA
I ultimately set this up so when I enter the utility room, the light will turn on (see .gif), and I get a push alert to my phone if the door stays open for more than a few seconds. Cats are not allowed in that room!!