Aqara Door & Window Sensor Trim Shim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Does your door have trim that makes in impossible to use a smart door sensor?! I have the parametric solution for you!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 152
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
This model is for the Aqara Door & Window Sensor (affiliate link), and helps you level the two pieces inline with any door or window trim.
My door has a ½ inch trim that frames it, and makes it not possible to keep the two pieces of the sensor flush making them not work well.
I needed a model that would raise the sensor inline with the trim so that both mate up well.
If your trim is different then ½ inch, update the model with the .f3d file included. All you need to do is update the parameter SH to your height in mm.
In Fusion 360 → Open Model → “Modify” Drop Down → “Change Parameters” → Update “SH” to Desired Height → Click “OK”
Printer settings:
- .2mm height
- .4 Nozzle
- 10% infill
- PLA
I ultimately set this up so when I enter the utility room, the light will turn on (see .gif), and I get a push alert to my phone if the door stays open for more than a few seconds. Cats are not allowed in that room!!