1 / 6
FPV screen (betafpv VR03)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Handy fpv spectator screen case, using Betafpv VR03 electronics
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 73
- Makes
- 0
- Views
- 310
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Parts are easy and fast to print
I used PLA and PLA+ for filament
Lid for the case is snap on (you can use some CA-glue to hold it firmly).
Battery has its own compartment in the bottom of the case, but I used some strips of duct tape to keep it still.
Hardware needed to assembly:
4x M3x5mm bolts
4x rubber o-rings for the bolts
u.FL to SMA 10cm pigtail (I haven't tested the original RP-SMA pigtail if it fits)
- Place the battery to its holder on bottom of the case
- Drop 4 buttons to their holes
- Place the SMA(or RP-SMA) pigtail to its mounting hole
- Screw the PCB with 4 M3x5mm bolts and rubber o-rings
- Attach battery plug to pcb
- Mount the screen to the lid (notice that it fits on one way only)