Bookshelf Speaker Stands for desk

I needed a speaker stand to angle my Q Acoustic 3010i speakers up on my desk. I need to give all the design credit to Wise Idea @W_1366851 for their speaker stands for the 3020i's. https://www.printables.com/model/894671-speaker-stand/comments

I had hoped a simple scale down this model but unfortunately I needed to completed build the design of my stands from scratch on 360 as the size of the smaller 3010i's are not directly proportional to the larger 3020i. 

Additional changes; 

1. To isolate the stand from my desk to prevent vibrations and to stop it from easily sliding I added in cut outs to add rubber feet to the bottom (pictured)
2. To better secure the speaker to the stand I added cut outs for the speakers feet to slot in to
3. The angle of the stand was increased to a steeper 12degree to suit my setup and height

There are 2 files, 1 with and 1 without the cut out for the feet. The later may work with other similar sized speakers. However the one with the cut outs will be very specific to the Q Acoustic 3010i's.

Printed with wood colour PLA from Elegoo.

15% gyroid infill

0.15 layer height for a better finished look

Supports are needed for the model with the feet cut out. As they are only 2mm deep, use grid supports