1 / 4
GMKtec G9 NAS Vertical enclosure for USB Fan and Heatsink
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thanks to Jeff Geerling for the inspiration to create this ;)
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 114
- Makes
- 0
- Views
- 910
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
When Jeff Geerling published his review of the GMKtec G9 NAS box, I knew I could get this thing to work a little better for myself - So I got one, chucked an aluminum heatsink on some SSDs I had laying around and created this vertical stand.
Printed mine with some PLA I had left over, hence the two-colored look of it.
BOM:
- https://www.amazon.de/dp/B0DT4HSJHF - GMKtec G9 Intel N150 12GB DDR5 / 64GB EMMC (incl. 512GB M.2 SSD)
- 4x https://www.amazon.de/dp/B0BY6QB7HZ - Basically: 3-4x PCIe Gen.3 NVMe SSDs of your choice.
- 4x https://www.amazon.de/dp/B09V52W7JH - Heat sink pads
- https://www.amazon.de/dp/B0BRQMB8CG - Alumin(i)um heat sink - Cut to size to fit back panel hole
- https://www.amazon.de/dp/B07DXMF32M - USB fan
Assembly:
- Remove back panel from NAS box
- If using four of your own drives: Remove included SSD
- Install your SSDs
- Install cooler over SSDs by sticking it onto the pads
- Install USB fan in back of enclosure - Take out rubber grommets on back of the fan
- Slide the NAS box in place with the open aluminum heat sink at the back
Et voilà :)
---
Also, nota bene, I was originally trying to find a pre-existing holder for the NF-A8 5V fan I used, and while I haven't incorporated it into my design directly, this one from Alnomis was a good inspiration.