GMKtec G9 NAS Vertical enclosure for USB Fan and Heatsink
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thanks to Jeff Geerling for the inspiration to create this ;)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 910
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
When Jeff Geerling published his review of the GMKtec G9 NAS box, I knew I could get this thing to work a little better for myself - So I got one, chucked an aluminum heatsink on some SSDs I had laying around and created this vertical stand.
Printed mine with some PLA I had left over, hence the two-colored look of it.
BOM:
- https://www.amazon.de/dp/B0DT4HSJHF - GMKtec G9 Intel N150 12GB DDR5 / 64GB EMMC (incl. 512GB M.2 SSD)
- 4x https://www.amazon.de/dp/B0BY6QB7HZ - Basically: 3-4x PCIe Gen.3 NVMe SSDs of your choice.
- 4x https://www.amazon.de/dp/B09V52W7JH - Heat sink pads
- https://www.amazon.de/dp/B0BRQMB8CG - Alumin(i)um heat sink - Cut to size to fit back panel hole
- https://www.amazon.de/dp/B07DXMF32M - USB fan
Assembly:
- Remove back panel from NAS box
- If using four of your own drives: Remove included SSD
- Install your SSDs
- Install cooler over SSDs by sticking it onto the pads
- Install USB fan in back of enclosure - Take out rubber grommets on back of the fan
- Slide the NAS box in place with the open aluminum heat sink at the back
Et voilà :)
---
Also, nota bene, I was originally trying to find a pre-existing holder for the NF-A8 5V fan I used, and while I haven't incorporated it into my design directly, this one from Alnomis was a good inspiration.