1 / 4
OUTDATED smthng display housing 1 (glue edition) for GaggiMate
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimalist housing with adhesive solution for the GaggiMate display (LILYGO T-RGB, 2.1 inch)
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 258
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
No longer current, version 1.6 of the “press fit” versions replace the “glue” versions, see table below:
smthng display housings for GaggiMate:
| smthng display housing 1 (press fit) | smthng display housing 1 (press fit and back clip) | OUTDATED smthng display housing 1 (glue edition) | smthng display housing 2 (with frame) |
|---|---|---|---|
|
|
|
|
| https://www.printables.com/model/1316664-smthng-display-housing-1-press-fit-for-gaggimate | https://www.printables.com/model/1329574-smthng-display-housing-1-press-fit-and-back-clip-f | https://www.printables.com/model/1325292-smthng-display-housing-1-glue-edition-for-gaggimat | https://www.printables.com/model/1325639-smthng-display-housing-2-with-frame-for-gaggimate |
smthng display housing 1 (glue edition):
Installation
I recommend using double-sided adhesive tape and only sticking it to the thicker areas (as shown in the picture). This is enough to hold the display in place, but you can also carefully remove it again due to the small amount of adhesive.
Align the display as centrally as possible during installation.
How to print
- It is best to print at a 45 degree angle without supports (Warnings due to floating regions can be ignored).
- Or: If there are adhesion problems, the housing can also be printed flat on the back, but then supports should be activated.