1 / 4
Pavo20 Pro RunCam WifiLink2 Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Specialized bracket for mounting RunCam WifiLink 2 on the BetaFPV's Pavo 20 Pro drone.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 96
- Makes
- 0
- Views
- 402
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Highlights
- Weight-optimized at only 7 grams
- Covers the camera module from three sides at full tilt range (0-30deg)
- Two 3.5mm antenna mounts accommodate your favourite CP antennas
- Optional lightweight arms to use with simple dipoles that come in the RunCam kit
- Optional super-light fan guard
- Fully Customizable - grab the Fusion 360 or a STEP file and modify to your heart's contents
Printing instructions
- Use PETG or PC! Seriously, PLA is too rigid for the thinner parts and will creep over time resulting in antenna holders losing their grip.
- Use tree supports with zero interface layers. This is important! Interface layers make supports a royal pain to remove, especially from tight corners.
- Use 0.2mm layer height for a good balance between strength and detail
Assembly instructions
- Pre-thread the holes to about 2mm deep before mounting on the quad
- Slip the front edge of the WifiLink2 module in first, then bend the bracket gently and push in the back
- Do not over-tighten the mounting screws, the rubber grommets should not be compressed
- Optional fan-guard must be glued in place. Liquid super-glue works really well. Dry-fit first! Use a knife with a sharp tip to remove burr from the tiny edges and slots if necessary. Apply a drop of glue to each slot, press gently in place and leave to dry for 10 minutes.
That's it. Enjoy!