Monkey Wrench Bottle Opener

Remix of my own earlier design.  This Pipe wrench is special and will remove most beverage pry off tops, twist tops, and most any tops under Ø32mm.  Most of this will print just fine as is with only three manually placed supports, 2 on the Jaw, on both sides of the jaw “teeth”, and one on the Handle, just below where the nut sits to support between the gap the jaw goes through.   I did have to use a brim on the top jaw, as some of the threads will not stick to a bed very well.  Other parts will print with a skirt or possibly nothing at all.   I would suggest 5-8 walls, high infill, or both for strength.  See image included for manual supports.