1 / 4
Creality K1 – Fan Seal Plate (MCU Cooling Improvement) — image 1
1 / 4

Creality K1 – Fan Seal Plate (MCU Cooling Improvement)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Removes the gap between the fan & the base, bringing in new air & not circulating it upon itself.

Rating
5 / 5
Likes
11
Downloads
88
Makes
2
Views
467
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution

Creality K1 / K1 Max – Fan Seal Plate (MCU Cooling Improvement)

On the original Creality K1 and K1 Max, the stock 6015 MCU cooling fan is mounted on four posts beneath the printer’s bottom plate. This leaves the fan sitting approximately 4 mm above the intake holes, allowing it to draw air from inside the printer as well as from the intended external intake.

This simple spacer/seal plate addresses that issue by:

  • Sealing the fan directly to the intake holes

  • Eliminating the ~4 mm gap between the fan and the bottom plate

  • Ensuring all intake air is drawn from outside the printer, not from inside the enclosure

On my printer, this resulted in a noticeable ~5 °C reduction in MCU temperature.


⚠ Compatibility Notice (Important)

This model is designed for the original K1 / K1 Max.
Later revisions (such as the K1 SE) appear to have changes in this area, and the gap this part addresses may already be reduced or eliminated.

Before printing, it’s recommended to:

  • Remove the bottom plate

  • Measure the gap between the MCU fan and the intake plate

If there is little or no gap, this part may not be required. Advanced users may scale the height in the slicer if desired.


Printing Notes

  • No supports required

  • PLA is fine; I printed in PETG

  • Any material you’re comfortable printing will work

  • This area does not experience high temperatures


Installation

  1. Remove the bottom plate (6 screws)

  2. Remove the MCU fan screws (4 screws)

  3. Place the seal plate onto the mounting posts

  4. Reinstall the fan using the original screws


This mod improves airflow efficiency and helps keep the MCU cooler on affected K1 models. A quick and easy upgrade where the gap exists.


 

Photos

 

It seems there is 2 types of fans, you mat notice the fan on the right in indented holes to allow for a closer fit to the base plate. It still leaves a gap. This plate works with both fans.

 

This was how my fan looked prior to the mod. A 4mm gap, which the fan would basically recirculate air. 

This is after, noting the fan essentially sits flush with the base plate.

Tags