Half gallon carton handle for milk or juice
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This holds a 100 x 100 mm carton of milk or juice to make pouring easier for those who have a hard time gripping one.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 37
- Makes
- 1
- Views
- 217
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My mother-in-law didn't want to pay for something similar from Amazon, so my wife told her I could print one, which she didn't believe…. challenge accepted… :-)
I couldn't find a free model that I liked, so I decided to design one from scratch. I printed a 40-layer base plate to start with. I didn't like the gaps that had to be filled in the corners, so I redesigned it in Blender using solidify to make the wall thickness equal all-around and switched the wall generator to Arachne to make sure there were no tiny gaps left. I then mocked up the whole model similar to the final version, except without the cutout in the back panel and with a thicker handle. I printed that out with 1 wall loop and 10% infill to get a quick prototype. I then took that to the grocery store and test it out on several different containers.
Satisfied that the overall design seemed to work, I reduced the diameter of the handle and added a couple more millimeters between the handle and the back plate. I really wanted the filament usage under 250 g so that it used less than ¼ of a spool, so I added a cutout to the back panel as well and made the others slightly taller. I printed a prototype of the main grip of the handle to make sure I reduced the diameter enough, which I hadn't, so I reduced it a little more. I also wanted the handle to have more grip, so I printed a small portion of the handle with different fuzzy skin settings and asked my wife which she preferred.
Here are the slicer settings I altered from default:
Brim type: No-brim
Elephant foot compensation: 0.2
Wall generator: Arachne
Walls printing order: Inner/Outer/Inner
Wall loops: 3
For the handle, I added a cylinder-shaped object modifier with a size of 40 x 40 x 90 mm and placed it over the handle as seen in the slicer screenshot. Then under Other settings I set:
Fuzzy skin: Contour
Fuzzy skin point distance: 1 mm
Fuzzy skin thickness: 0.2 mm
I printed this on my Elegoo Centauri Carbon using Elegoo PLA Pro. After accounting for the prototype costs, the material cost ended up being half of what Amazon wanted for one of these, adding in the labor however… Amazon would have been much cheaper! LOL
I did learn some new tricks with Blender and used some new slicer settings I hadn't before, so it was a good learning experience! Hopefully others might find this useful and put my labor cost to good use. :) Thanks!
