1 / 5
MonoBlock v3.12 & v3.15 (6MM & 8MM Axis) for Ultimaker 1, 2, 2+, GO, Connect, Extended — image 1
1 / 5

MonoBlock v3.12 & v3.15 (6MM & 8MM Axis) for Ultimaker 1, 2, 2+, GO, Connect, Extended

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

MonoBlock for 6 and 8mm X&Y axis for Ultimaker 1,2,2+,GO,Connect,Extended

Rating
0 / 5
Likes
1
Downloads
10
Makes
0
Views
125
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

MonoBlock v3.12 (6MM & 8MM) axis

This block will not only enable you to convert your standard Ultimaker print head from 2.85mm filament to 1.75mm filament, but will also enable structural integrity and rigidity for higher quality prints.

Once printed, it is highly recommended all holes are drilled for easier installation. Bearing holes are to be drilled and/or reamed to 12/15mm for best fitment of bearings. The block clamping holes are also be drilled to 3mm. Bowden coupler hole was designed to be tapped to M6 thread. There is also small holes to be tapped to m2.5 for grub screws to hold the bearings in place should they need to be held in place.

Hardware Needed:
2x M3x65
2x M3x50
4x LM8U 8x15x17 linier bearings (purchased form AliExpress)
Bowden coupler connector is 4mm x m6 thread.
Small ZipTie

As always, I look forward to seeing your prints and feedback.

Tags