1 / 5
MonoBlock v3.12 & v3.15 (6MM & 8MM Axis) for Ultimaker 1, 2, 2+, GO, Connect, Extended — zdjęcie 1
1 / 5

MonoBlock v3.12 & v3.15 (6MM & 8MM Axis) for Ultimaker 1, 2, 2+, GO, Connect, Extended

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MonoBlock for 6 and 8mm X&Y axis for Ultimaker 1,2,2+,GO,Connect,Extended

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
125
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

MonoBlock v3.12 (6MM & 8MM) axis

This block will not only enable you to convert your standard Ultimaker print head from 2.85mm filament to 1.75mm filament, but will also enable structural integrity and rigidity for higher quality prints.

Once printed, it is highly recommended all holes are drilled for easier installation. Bearing holes are to be drilled and/or reamed to 12/15mm for best fitment of bearings. The block clamping holes are also be drilled to 3mm. Bowden coupler hole was designed to be tapped to M6 thread. There is also small holes to be tapped to m2.5 for grub screws to hold the bearings in place should they need to be held in place.

Hardware Needed:
2x M3x65
2x M3x50
4x LM8U 8x15x17 linier bearings (purchased form AliExpress)
Bowden coupler connector is 4mm x m6 thread.
Small ZipTie

As always, I look forward to seeing your prints and feedback.

Tagi