Quick release endcap holder for Wahoo Kickr v3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds the endcaps for running a quick release equipped bike on a Wahoo Kickr v3 for convenient storage.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a simple holder for the endcaps that fit a Wahoo Kickr v3. (2017) Might fit other Kickrs, I'm not sure and don't have any to check. This just holds the three pieces that go on the trainer to use a bike with a quick release axle when you're storing them because you've got something else installed on the bike.
Non drive side insert goes in the large end, then the threaded cap goes on the threads (duh) and the drive side QR insert goes inside that. Easy peasy chicken dinner.
For reference, the threads are an M16x1.0.
Print instructions
Print it strong enough that it doesn't fall apart. Beyond that, completely up to you. Should need no supports. I think I did 0.2mm layer height with a 0.4mm nozzle and three shells.