Mad Catz Tournament Edition Round 1/2 Display Panel for SSD1306 0.96" OLED

Mad Catz Tournament Edition Round 1/2 Display Panel for SSD1306 0.96" OLED

Alternate option panel for the Mad Catz Tournament Edition Round 1/2 adapting my mount for SSD1306 0.96" OLED displays.

A small part of the cable compartment will have to be cut away for the display to fit, depending on which version of the print you use. 
The buttons I used also needed a small hole drilled for each of them so the pins could fit. 
Versions for buttons of either 10 or 12 mm in diameter are included. 

Versions: 

All three are available with the display either centered or on the right side, both with holes for either 10 or 12 mm buttons.

• Standard

  • Simple flat version with centered display, easy to print upside-down

• Art overlay

  • simple flat version with centered display, slightly lowered surface to be flush with the metal panel so acrylic cover and art can be overlaid

  • Includes cutout guide on separate print plate

  • No picture included of this version as of yet!

• With rib

  • Centered display

  • Panel surface is lowered by 1.5 mm to allow for the rib

  • This version is best printed top-side up. Some cleanup from the supports on the display mount will be necessary to make it fit (see picture below for the specific area). Don't remove too much or it might result in a loose fit.

Any suggestions are welcome. 

I tried adapting a nice mesh made by Yannichaboyer, "Custom control panel for Mad Catz Fighstick Pro PS3/Xbox360" but wasn't able to use it, Fusion really butchered it on import. Might be easier with a paid version that has their prismatic mesh conversion.