1 / 9
Meshtastic Seeed Studio Xiao ESP32S3 & Wio SX1262 case MOD 1.3 OLED — image 1
1 / 9

Meshtastic Seeed Studio Xiao ESP32S3 & Wio SX1262 case MOD 1.3 OLED

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Rotate the board & move the USB port to the side, use 1.3 OLED screen, a bit wider and thicker dimensions.

Rating
0 / 5
Likes
9
Downloads
62
Makes
0
Views
1,136
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The changes I made:

  1. Rotated the board & moved the USB port to the side instead of the top. (edit, both top and side versions are available)

  2. I used a 1.3 OLED instead of 0.96 (pls excuse my old eyes).

  3. Widen the case size (width and thickness) to fit the size of the display board & battery I used for easier installation.

  4. Added a simple Meshtastic logo.

  5. Add versions with various hanger/hook.

Note: The image displayed is an initial design, I have revised it a little, especially the gap on the side of the screen.

16/02/2026 (1) - Fix minor issue.

16/02/2026 (2) - Add new version with a hole for easy hanger/hook.

18/02/2026 - Add new versions with various hanger/hook, and some minor fixes.

Battery: I use a 1200 mAh Lipo (103040) battery so it is a bit thicker and difficult to fit in the original case, the current design is more flexible in the size of the battery you can insert.

Slide Switch: In the original design, it use a sub-miniature or micro-miniature (or something like that) slide switch, alternatively you can use a switch with the SS12F15 type (main body length around 10-11 mm and width/depth 5-6 mm) with a maximum stem length of 5 or 6 mm (The length of the switch guard is 6 mm so don't exceed it).

Button: I recommend tactile button with total height of 6 mm, which I think are easier to press than 5 mm. If use 7 mm it might be too long and likely prone to accidental press.

PS: I also just learned that not all GPIOs can be used for buttons. Previously, I used GPIO 8, but the board would restart when I tried to change some settings. I tried GPIO 7 but it was the same, and GPIO 9 worse, failed to get to the main menu. It turns out those are all SPI pins and can't be used, so I finally moved to GPIO 4.

For the rest explanation, you can check on the previous model or the original design.

Tags