(REV2) ENDER 3 V2 - Raspberry Pi zero 2W case and PiCam mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pi Camera mount with Raspberry Pi Zero 2W case for Creality Ender 3 V2
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 177
- Makes
- 1
- Views
- 1,994
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is a remix of three models
Camera bracket:
https://www.printables.com/en/model/157687-ender-3-v2-gantry-adjustable-pi-camera-bracket
Case:
https://www.thingiverse.com/thing:1167846
Camera bracket mount:
https://www.printables.com/cs/model/30752-ender-3-x-pulley-cover
This model is for ENDER 3V2.
It allows you to use a pi camera with an RPI zero 2w (I believe no one sells zero edition cables longer than 30cm).
I'm using PiCam version 1, but the design should be compatible with version 2.
Compatible with BL Touch and other variants. Both revisions make enough space for it. (they do not interfere with reaching the endstop)
REV2:
This revision makes it simple to mount the entire system.
REV1:
edits:
I modified the arm and made the Backplate "ball" smaller.
For simplicity of installation, I provided recessed holes into which M3 nuts could be installed.
Because the fit is so tight, you'll want to make sure your printer is set to maximum dimensional accuracy.
The bracket was installed with 12mm M3 socket cap bolts.
I just used electrical tape to keep it in place.
That, I believe, is sufficient.