1 / 10
Magnetic stirrer made from an upcycled 70mm fan — image 1
1 / 10

Magnetic stirrer made from an upcycled 70mm fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

magnetic stirrer with 5.5mm × 2.5mm socket, waterproof cap, adjustable power supply, and anti vibration feet

Rating
0 / 5
Likes
3
Downloads
6
Makes
0
Views
98
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

This magnetic stirrer is built around a recycled standard 70mm PC fan. The model is designed as a screw-together assembly where, once finished, the 5.5mm × 2.5mm jack locks into the housing in a form-fit way.

To ensure durability in a lab environment, the matching protective cap includes a sealing ring, making the unit splash-resistant.

Mechanical Assembly & Internal Mounting

The fan is mounted inside the housing using four M4 × 8 mm cylinder head screws (Hex 3) and is further stabilized by the internal walls of the print.

  • Magnet Setup: I used Ø10mm × 6mm magnets glued onto a mounting plate attached to the fan hub.

  • Vibration Management: Since centering magnets perfectly on a fan hub is challenging, the design includes anti-vibration feet.

  • Screw Clearance: These feet provide enough clearance for the mounting screws to protrude slightly. For vibrating parts, it is generally helpful if screws extend about one thread past the nut.

Material Choice & Finishing

Once the lower section is assembled, the lid can be screwed on. Depending on your filament choice, the thread might require light sanding. While a test print in standard PLA screwed together perfectly, the final version in FiberWood needed minor adjustments. However, the resulting surface texture gives the model a premium "single-piece" look.

Wiring & Final Steps

After the mechanical assembly, the power jack must be soldered.

  1. Route the fan cable through the internal slot.

  2. Pull it through the flush exit hole. (Keeping the foot hole open at this stage makes positioning the cable much easier).

  3. Solder the wiring and screw in the power jack.

  4. Snap the feet into place and plug in the power supply.

Stirring Options

You can use standard magnetic PTFE stir bars. Alternatively, it is easy to build custom stir bars using small rods with magnetic ends or weak bar magnets.


Parts Used

Additionally Required

  • Magnets: Ø10mm × 6mm

  • Fan: One 70mm PC fan (25 mm thick)

  • Note: The magnets and fan were salvaged parts, so no specific links are provided.

Tags