1 / 1
Snap-in Cable Holder for Alutec 45x45 / Držák kabelů Alutec 45x45 — image 1

Snap-in Cable Holder for Alutec 45x45 / Držák kabelů Alutec 45x45

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

EN Holder for Alutec KK 45x45, 8 mm slot. CZ Držák kabelů pro profil 45x45, drážka 8 mm.

Rating
0 / 5
Likes
4
Downloads
18
Makes
0
Views
89
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Snap-in Cable Holder 45x45

Snap-in cable holder for Alutec KK 45x45 aluminum profile with 8 mm slot.

Designed for this profile:

https://katalog.aluteckk.cz/produkt/profil-45x45-ekonomicky-104545e/

The holder is inserted into the slot and locked by rotating it 90° counter-clockwise.

Use

This part is intended for simple cable routing along Alutec KK aluminum profiles. It helps keep cables close to the profile without drilling, screws, or extra hardware.

Compatibility

  • Alutec KK 45x45 aluminum profile

  • 8 mm slot

  • Designed around profile 104545E

Recommended print settings

  • Material: PETG

  • Basic print settings are sufficient

  • 2 perimeters are usually enough

  • No supports needed

  • Print one test piece first and check the fit in the profile slot

Installation

  1. Insert the holder into the 8 mm profile slot.

  2. Rotate it 90° counter-clockwise.

  3. Route the cable through the holder.

The fit may depend on printer calibration and filament.


Zacvakávací držák kabelů 45x45

Zacvakávací držák kabelů pro hliníkový profil Alutec KK 45x45 s drážkou 8 mm.

Navrženo pro tento profil:

https://katalog.aluteckk.cz/produkt/profil-45x45-ekonomicky-104545e/

Držák se zasune do drážky a upevní otočením o 90° proti směru hodinových ručiček.

Použití

Díl slouží pro jednoduché vedení kabelů podél hliníkových profilů Alutec KK. Kabely drží u profilu bez vrtání, šroubování nebo dalšího spojovacího materiálu.

Kompatibilita

  • Hliníkový profil Alutec KK 45x45

  • Drážka 8 mm

  • Navrženo podle profilu 104545E

Doporučené nastavení tisku

  • Materiál: PETG

  • Stačí základní nastavení tisku

  • Obvykle postačují 2 perimetry

  • Podpory nejsou potřeba

  • Nejprve doporučuji vytisknout jeden zkušební kus a ověřit usazení v drážce profilu

Montáž

  1. Držák zasuňte do 8mm drážky profilu.

  2. Otočte jej o 90° proti směru hodinových ručiček.

  3. Vložte nebo veďte kabel držákem.

Přesnost uchycení může záviset na kalibraci tiskárny a použitém filamentu.

Tags