TZ V6 HotEnd mount for EVA 3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hot end mount for the popular TZ V6 hotend. For the EVA v.3 printhead often used as an alternative to Stealthburner.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 28
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This will fit the popular TZ V6 hotend often found on AliExpress and Amazon. It will fit both TZ V6 version 2.0 and 3.0, but you must remove the top part, the "V6 groove", and fasten it with 4pcs M2.5 screws from above, the screws included with the hotend will fit, think they are between 6mm and 8mm. You must tighten the screws a little at a time in a circular pattern, do not use much force. Maybe make sure the PTFE tube will fit before you fasten the hotend in case you have to widen the hole for the tube with a drill. I used painted tree support, see the green dots on the picture. Use the regular cooling duct. not the volcano type. The model is not perfect so if you remix it further for this hotend please post in comments so others can use it as well. Printed with 3-4walls and 3-4 top/bottom layers and 15% gyroid infill, I used 0.28mm layer height but I don't think that is important. Please note that this is for the heat-insert option, not the hex nut option.
All credit to the open source EVA modular printhead project. Licence: CC BY-NC-SA 4.0
Website: main.eva-3d.page