Bearing Press Insert MR18307 (18×30×7) – M8 / 1/4" Compatible Hub Tool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printable bearing press insert for MR18307 (18×30×7) hub bearings. Designed for DIY press tools using threaded rod (M
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
This is a simple 3D printable bearing press insert designed specifically for MR18307 (18×30×7 mm) bearings, commonly used in bicycle hubs.
It is intended for use with a DIY bearing press setup (threaded rod + washers + nuts), allowing you to press bearings safely and evenly by applying force only to the outer race.
The center hole is designed to fit an M8 threaded rod (clearance is included).
It is also compatible with 1/4" threaded rod (common in imperial systems), with a slightly looser fit.
Printing recommendations
- Material: PETG recommended (PLA works too)
- Infill: 40–60%
- Walls: 4+ perimeters
- Orientation: flat on the bed
- Supports: not required