Portable Ham Radio Hex Antenna Center Hub for 20m to 6m
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printed center hub for a portable ham radio hex antenna, designed for telescopic poles and field use from 20m to 6m.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 69
- Makes
- 0
- Views
- 451
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Description
This is a 3D printed center hub for a portable ham radio hex antenna, designed for field use with telescopic poles.
The hub is intended for building a lightweight portable wire antenna for amateur radio operation. It was made for use with common telescopic poles around 5 meters in length, the type often sold on eBay and similar stores. The poles I used have a metric screw thread, but thread size may vary between different pole models, so please check your own pole before printing or modifying the model.
The antenna was designed and tested for amateur radio bands from 20m to 6m.
In my field testing, this antenna worked very well as an NVIS / portable antenna setup. So far, it has been my best antenna for working on 14 MHz / 20m, with very good results across Europe and parts of Asia and Africa.
For Oceania and America, this is probably not the ideal antenna in my location and setup. For that kind of DX work, a vertical antenna or another low-angle radiation setup may be a better choice.
Main features
3D printed center hub for a portable hex-style wire antenna
Designed for amateur radio field use
Suitable for telescopic poles around 5m long
Designed for bands from 20m to 6m
Lightweight and easy to transport
Useful for portable operation, field days, SOTA, POTA, and temporary antenna setups
Tested successfully on 14 MHz / 20m
Material recommendation
I strongly recommend printing this part in PETG.
PLA is not recommended for long outdoor use because it can soften and deform in direct sunlight or high temperatures. Since this part is exposed to sun, mechanical stress, and outdoor conditions, PETG is a much better choice.
Print settings
Recommended material: PETG
Layer height: 0.2 mm
Infill: 40–60%
Walls/perimeters: 4 or more
Top/bottom layers: 5 or more
Supports: depends on print orientation
For field use, mechanical strength is more important than print speed. Use enough walls and infill so the hub can handle tension from the wire elements and stress from the telescopic poles.
Notes
This is a mechanical antenna hub only. The final antenna performance depends on wire lengths, band setup, feed point, matching, installation height, location, and surrounding terrain.
This is not a commercial antenna product. It is a DIY ham radio part designed for practical portable use.
The model was designed from scratch in Autodesk Fusion 360.
