Ryobi Battery to Craftsman V20 Battery Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use Craftsman V20 batteries on your old Ryobi tools.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Background
I have several Ryobi tools with original batteries that are about ten years old. Only one battery is holding a charge. I have since started purchasing Craftsman V20 tools on sale and now have a sizeable battery collection. Rather than using two battery systems, I made this adapter. I could have purchased a similar product, but it looked rather expensive for what it is and I thought this would be a good exercise in 3D modeling.
Design Goals:
No soldering or wiring--use a single conductor from tool to battery
No additional hardware--non-removable snap fit, no screws or threaded inserts
Single print--minimize assembly
Close to OEM fit--good enough for old tools
Additional Materials Needed:
1.0mm x 10mm x 400mm Copper bar 2X cut to 66mm, use the cutting jig to make a square line.
Assembly Notes:
I've added a bar cutting jig that is 66mm. Slide the bar in and mark with a razor blade. Then line the diagonal cutters along the line. Bend and snap. This provides a fairly clean break most of the time. Gently pound the bar into the slot from the bottom (Craftsman) side. It will seat below the bottom surface. You may need to clean up the edge with a file and you may need to adjust the spacing slightly the bars by bending them towards or from the wall. They should line up with the edge of the chamfer.
Additional Notes:
Ryobi contact spacing is 20.5mm and Craftsman contact spacing is 27.5mm. See cross-section photo. This is why the bar must be pounded in. Also, be sure to insert the contacts before attaching to the tool--you may not be able to remove the adapter easily. I printed in PLA.