1 / 2
Sonos ZP120 (CONNECT:AMP) Under-Desk / Shelf Mount — image 1
1 / 2

Sonos ZP120 (CONNECT:AMP) Under-Desk / Shelf Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Keep your desk clean and elevate your setup by mounting your Sonos ZP120 (CONNECT:AMP) underneath any shelf or desk.

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
23
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Keep your desk clean and elevate your setup by mounting your Sonos ZP120 (CONNECT:AMP) underneath any table, shelf, or desk.

This design utilizes a sandwich clamp mechanism featuring four structural corner columns that clamp the amplifier securely in place without stressing the plastic body of the Sonos unit. The open-frame design ensures optimal airflow and passive cooling while giving easy access to front controls and rear wiring.

Bill of Materials (BOM)

Printed Parts:

  • 1x Top Plate (Mounts directly to the underside of the desk/table)

  • 1x Bottom Plate (Cradles the bottom of the Sonos unit)

  • 4x Corner Standoff Columns (Acts as structural spacers and locks the unit into the bottom plate)

Hardware Required:

  • 4x M8 Hex Bolts — 120mm length (excluding head)

  • 4x M8 Nuts

  • 4x M8 Washers (Outer diameter ≤20mm)

  • 12x Countersunk Screws — 3.5mm diameter (length chosen based on your desk thickness)

Recommended Print Settings

  • Top Plate & Bottom Plate:

    • Material: PETG (Recommended for long-term load bearing and heat resistance)

    • Infill: 25–30% (Gyroid or Grid)

    • Walls/Perimeters: 3 to 4 walls for strong screw hole retention and rigidity

  • Corner Standoff Columns:

    • Material: PETG recommended, but PLA / ABS / ASA will work fine as these parts are purely under compressive load.

    • Infill: 15–20%

Assembly Instructions

  1. Prep the Top Plate: Pass the four M8 bolts downwards through the dedicated holes in the Top Plate so the heads sit flush/recessed against the mounting surface.

  2. Mount to Desk: Secure the Top Plate to the underside of your desk or shelf using the 12 countersunk 3.5mm screws.

  3. Attach Standoff Columns: Slide the 4 Standoff Columns over the hanging M8 bolts. (Pro Tip: Use a small piece of painter's tape on each column to hold them temporarily in place so they don't fall off).

  4. Insert Sonos Unit: Slide the Sonos ZP120 into place between the standoffs, followed by the Bottom Platepassing over the M8 bolt ends.

  5. Lock Down: Place an M8 washer and M8 nut on each bolt end and hand-tighten evenly until firm and secure.

If you print this model, please post a make! Feedback and suggestions are always welcome.

Tags