Sonos ZP120 (CONNECT:AMP) Under-Desk / Shelf Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your desk clean and elevate your setup by mounting your Sonos ZP120 (CONNECT:AMP) underneath any shelf or desk.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Keep your desk clean and elevate your setup by mounting your Sonos ZP120 (CONNECT:AMP) underneath any table, shelf, or desk.
This design utilizes a sandwich clamp mechanism featuring four structural corner columns that clamp the amplifier securely in place without stressing the plastic body of the Sonos unit. The open-frame design ensures optimal airflow and passive cooling while giving easy access to front controls and rear wiring.
Bill of Materials (BOM)
Printed Parts:
1x Top Plate (Mounts directly to the underside of the desk/table)
1x Bottom Plate (Cradles the bottom of the Sonos unit)
4x Corner Standoff Columns (Acts as structural spacers and locks the unit into the bottom plate)
Hardware Required:
4x M8 Hex Bolts — 120mm length (excluding head)
4x M8 Nuts
4x M8 Washers (Outer diameter ≤20mm)
12x Countersunk Screws — 3.5mm diameter (length chosen based on your desk thickness)
Recommended Print Settings
Top Plate & Bottom Plate:
Material: PETG (Recommended for long-term load bearing and heat resistance)
Infill: 25–30% (Gyroid or Grid)
Walls/Perimeters: 3 to 4 walls for strong screw hole retention and rigidity
Corner Standoff Columns:
Material: PETG recommended, but PLA / ABS / ASA will work fine as these parts are purely under compressive load.
Infill: 15–20%
Assembly Instructions
Prep the Top Plate: Pass the four M8 bolts downwards through the dedicated holes in the Top Plate so the heads sit flush/recessed against the mounting surface.
Mount to Desk: Secure the Top Plate to the underside of your desk or shelf using the 12 countersunk 3.5mm screws.
Attach Standoff Columns: Slide the 4 Standoff Columns over the hanging M8 bolts. (Pro Tip: Use a small piece of painter's tape on each column to hold them temporarily in place so they don't fall off).
Insert Sonos Unit: Slide the Sonos ZP120 into place between the standoffs, followed by the Bottom Platepassing over the M8 bolt ends.
Lock Down: Place an M8 washer and M8 nut on each bolt end and hand-tighten evenly until firm and secure.
If you print this model, please post a make! Feedback and suggestions are always welcome.