Umbrella Tip Repair / Schirmspitzenersatz
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Repair of umbrella tip
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 42
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Men
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
EN:
The plastic tip on my Knirps men's umbrella broke. A replacement was needed.
The .3mf file includes a modification cylinder (PrusaSlicer) to increase the infill to 100% in the lower section, while I had set the infill to 40% in the upper section. The .stl file contains the bare part, since modifiers from PrusaSlicer are interpreted as a solid body in .stl and some other slicers.
Material: PETG, PCTG, PLA
Layer thickness: 0.2 mm
Supports: none
UUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUU
DE:
Bei meinem Knirps Herrenschirm zerbrach die Kunststoffspitze. Ersatz musste her.
Die .3mf-Datei beinhaltet einen Modifizierungs-Zylinder (PrusaSlicer) um im unteren Teil das Infill auf 100% zu erhöhen, während im oberen Teil ich das Infill auf 40% eingestellt hatte. Die .stl-Datei beinhaltet das nackte Teil, da Modifizierer aus dem PrusaSlicer in .stl bzw. so manchem anderen Slicer als kompakter Körper interpretiert werden.
Material: PETG, PCTG, PLA
Schichten: 0.2mm
Stützen: keine