Stealth Changer - Gantry Mounted X Endstop

I wanted a simple, small and easy to install gantry mounted x endstop solution for V2.4's that cant run a toolhead mounted x endstop either because you are running a tool changer or for whatever other reason. Simply unscrew the bottom screw nearest the motor from the motor mount plate and install the endstop mount with the same exact screw. The mount will sit flush against the nema17 motor and be held in place by the motor body.

For wiring, I used solid core wire for wiring the endstop to the female JST connector at the base of the mount to keep everything rigid and in place. 

For the endstop itself, you can buy the ones with pre-bent legs but its not necessary. It will work with a "normal" straight pin endstop as well. You can also run it without the lever arm on the endstop but I would advise against that for reliability reasons. 

The x-endstop depressor for the stealth changer shuttle is a separate model on my page, so if you need that just look in my models.