Atlas Scientific i4 InterLink enclosure – pH / EC / RTD + XIAO ESP32-C6 (ESPHome)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Screwless enclosure for the Atlas i4 InterLink with EZO pH, EC, RTD and a XIAO ESP32-C6 running ESPHome.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Open Community License v1.1 + General Attribution v1
Slim enclosure for an Atlas Scientific i4 InterLink with EZO-pH, EZO-EC and EZO-RTD circuits, plus a XIAO ESP32-C6 that sends the readings to Home Assistant. Running in my hydroponic setup.
Features
23 × 81 × 134 mm, no screws inside
i4 held on four ribbed pins, clamped by the lid
Four SMA connectors on the front, probe names above them
XIAO held by the snap-in retainer of my nutrient-jug scale, USB-C at the back
Snap-fit lid, magnets or screws underneath
File | Notes |
|---|---|
body_with_names_ASA.3mf | as exported, no supports |
lid_ASA.3mf | as exported, no supports |
xiao_retainer_ASA.3mf | as exported, no supports |
ASA, 0.2 mm layers, 4 perimeters, 40 % gyroid. The body file holds two parts, body and names: print it as is in one colour, or give the names a second filament on a multi-material printer.
boite_mesure_assemblage.step: the printed parts and magnets assembled, one named body each, for Fusion 360, SolidWorks or Onshape. Curved faces are faceted.
Hardware
Atlas i4 InterLink + EZO-pH, EZO-EC, EZO-RTD, switched to I²C first
Seeed XIAO ESP32-C6
3 magnets 19 × 9 × 4.6 mm, or 2 countersunk screws Ø 4 (optional)
USB-C cable + 5 V supply
Wiring
XIAO | i4 |
|---|---|
3V3 | VCC |
GND | GND |
D4 (GPIO22) | SDA |
D5 (GPIO23) | SCL |
EZO circuits in the three isolated slots: EC, pH, RTD from bottom to top. ⚠ The XIAO's 5V pin is an input: never USB and an external 5 V supply together.
Firmware
sondes-atlas.yaml.txt: ESPHome configuration, rename it to .yaml. Secrets: wifi_ssid, wifi_password, api_encryption_key. Temperature compensation and calibration from Home Assistant. ⚠ Keep GPIO14 low unless a u.FL antenna is plugged in.
License
Model: Open Community License v1.1 + GAtt. Firmware: MIT.