Dual Slim Optical Drive 5.25" Bay Adapter: Two Laptop DVD/Blu-ray Drives in One Bay (Parametric)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fit two slim (laptop-style) optical drives into a single 5.25" drive bay.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 8
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fit two slim (laptop-style) optical drives into a single 5.25" drive bay. I designed it for a Lenovo TS140 server used as a DVD ripping station, but it should fit any standard 5.25" bay.
Features
Holds two 12.7 mm slim optical drives, stacked, built to the SFF-8552 slim drive spec.
Each drive’s front sits flush with the adapter’s front, so the drive’s own tray faceplate clips on normally.
Matches the stepped shape of slim drives (the thin 1" ledge on one side). The thin side is solid under the ledge, so the drive is held firmly and can’t rock.
Mounts with the drives’ standard M2 side holes. The screw holes are slotted for a little front-to-back adjustment.
Solid floor, roof and middle divider make it rigid. The middle divider stops short of the back to leave room for SATA adapters and cables.
Fits standard 5.25" bay mounting holes.
No supports needed. Print it front-face down.
Print settings
Orientation: front face on the bed, as supplied.
Supports: none.
Material: PETG recommended. PLA is fine in a cool case.
0.2 mm layers, 3+ walls, 15–20% infill.
Hardware
8× M2×4 screws (4 per drive).
2× slimline SATA (13-pin) to standard SATA data + power adapters, one per drive.
4× 5.25" bay screws (M3 / 6-32) or your case’s tool-less pins.
A SATA power splitter if your PSU is short on connectors.
A screwdriver with a ~35 mm shaft to reach the thin-side screws through their access holes.
Before you print
Bay hole positions vary a little between cases. Check yours against an old 5.25" drive, or print the included 10 mm and 52 mm test slices first to check the drive fit and the bay holes.
Parametric
The OpenSCAD source is included. Everything is a variable at the top of the file: drive height (9.5 mm ultra-slim drives need different values), clearances, screw hole positions, bay hole positions, wall thicknesses and divider length.
