Butter Dish Replacement Flap with Snap-in Hinge (Tescoma FreshZONE)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement hinged flap for a butter dish. Snap-in hinge pins, latch included, measured from the original part.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Replacement flap (hinged lid) for a butter dish (Tescoma FreshZONE). The original part was damaged, so I measured it and redrew it in Fusion 360. Dimensions - Plate: 56 x 27.2 mm, 2.7 mm thick - Total height: 7.55 mm - Hinge: snap-in pins Ø 3.2 mm, 34.5 mm tip to tip - Snap latch on the long edge Print settings - Material: ASA (PETG should work too) - Orientation: flat side down, as in the file - Supports: not needed. The hinge pins have a small overhang; if they sag, enable supports just under the pins. - Layer height: 0.15–0.2 mm - Perimeters: 3–4 (the hinge and latch are thin) - ASA: use a brim and an enclosure to prevent warping The model is parametric. If it doesn't fit your butter dish, leave a comment with the hole diameter and spacing.