Low Profile Magnets for Laser Cutter Tables
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Turns standard 20mm magnets into work-holding tools for laser cutters like Epilog and Glowforge
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 33
- Makes
- 0
- Views
- 377
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Simple printable shroud that lets you turn 2 or 3 20mm x 3mm magnets available on Amazon into work-holding tools for use on a laser cutter. These let you stack 2-3 magnets on top of each other for maximum hold, and the printed lip makes them easy to remove. The whole assembly is short enough that your laser head should travel right over the top of them and not bump.
These are simple, quick prints, and work MUCH better than the myriad “pins” commonly available.
Recommended that you make ure you are getting complete coverage on your first layer, and/or bumping flow rate to above the standard to ensure plenty of plastic down on layer 1, as the bottom is only 1 layer thick at .20mm.
Recommended to print at .20mm.