1 / 5
Ender 3 Series Wire Clamp
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hot end wire clamp for direct drive mod
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 42
- Makes
- 0
- Views
- 289
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
This is a print for managing your hot end wires after a direct drive upgrade.
It mounts to the holes that the stepper motor mounted to for the bowden system.
For better wire support, run two lengths of 1.75 or one length of 2.85 PETG through the wire loom.
Zip tie pass through if you want to help keep it from slipping through the routing hole over time.
Best printing orientation is how the model is shown in the F360 photos above.
Minimal supports needed
Use M3x16 (at least 16mm in length) and M3 nuts to mount.