The vernier caliper: a new lease of life for defective electronic calipers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A new analog frame for a digital caliper of the Aldi "Workzone" brand and similar types.
- Rating
- 5 / 5
- Likes
- 65
- Downloads
- 99
- Makes
- 2
- Views
- 1,979
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Converting a broken electronic caliper to a vernier caliper
A few years back I bought a cheap caliper of the Aldi "Workzone" brand. This particular unit consumed batteries faster than I consume chocolate, and one day I found that the unit was dead: a drained battery had leaked and destroyed the electronics beyond repair.
However, the mechanical construction of these calipers is quite solid, so I converted my broken caliper into a unit that does no longer need batteries: Just like in the good old times, the sub-mm scale is read with a vernier scale (in German: "Nonius").

Materials
- 1 defective caliper
- 1 sheet of glossy white paper, or 1 transparent sheet for overhead slides
- 1 b/w laser or inkjet printer that can print on the aforementioned sheet without melting it
- Your preferred 3D printer and filament
Preparation
- Remove the broken electronics from the caliper: peel off the label on the back, unscrew all screws, remove the cover and continue removing screws until the unit falls apart ;-)
- Print the frame. The material does not matter (as long as it is solid 🤣)
- Print face down, as shown in the images.
- The thumb wheel needs support material - again, see images.
- The layer height determines the smoothness of the display "window", so you may want to use 0.2 mm or less.
- Clean the print by removing the support material.


Printing the Vernier scale
- Using a conventional 2D printer 😋, print the file “vernier-40mm.pdf”. You should obtain a grid pattern.
- Important: Print without any scaling.
- Verify that the distance between the first and the third thick grid line is exactly 39 mm.
- If this is not the case, something is wrong with your printer or your computer (printer scaling?) and you may want to get help.
- Cut a strip that is about 2.5...3 mm wide and about 43 mm long (i.e. there are exactly 10 lines). This is your new vernier scale.
Note: I printed this on a transparent sheet since I had planned to mount the vernier scale across the entire window of the frame. However, I actually prefer to have the scale right on the edge of the display → if you do not need the transparency, simply print on a sheet of (preferably glossy) paper.
Assembly

- Slide the thumb wheel into the frame. The wheel must spin freely.
- If it does not spin freely, take extra care to remove all the residues of the support material.
- Slide the new housing over the caliper, starting with the thumb wheel.
- Optional: Glue the frame to the caliper. I did not do this since the frame does not move (on my caliper).
- Set caliper to zero (leftmost) position.
- Align the strip with the vernier scale onto the lower, inner edge of the caliper "window" as shown in the photo below.
- The leftmost mark is exactly on the zero mark of the caliper.
- The 10th mark will automatically align on the 39-mm mark of the caliper scale.
- Carefully glue the strip in place, without changing its position.
- Done.

Enjoy :-)
Edit 2022-12-11: Added the FreeCAD source file, same license CC-BY-SA.
