Mk3 Full Bear 2040 Endcap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
There are a lot of endcaps out there for the 2040 extrusion used to construct the Full Bear upgrade to the MK3.
- Rating
- 4.667 / 5
- Likes
- 13
- Downloads
- 228
- Makes
- 5
- Views
- 1,140
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
There are a lot of endcaps out there for the 2040 extrusion used to construct the Full Bear upgrade to the MK3. I was having a hard time finding an endcap that slid into the end of the extrusion rather than down the front and sides. This presses into the hole at the end of the extrusion leaving no tabs to be seen.
STEP, f3d, and STL are available here for your customization pleasure.
Print instructions
It should be good to go in the orientation I have it set in the STL. You do you though.
No supports
Printed with a brim because PETG
I will note that I designed this leaving zero clearance. The printer I used has a pretty consistent .01mm of shrinkage so I knew it would fit. Just make sure you know your printer's capabilities and what happens to your prints after they are done and scale the files accordingly.
Happy Printing.