KitchenAid Sandwich Toaster Clamp Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A grip replacement for sandwich clamps for KitchenAid toasters.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 23
- Makes
- 0
- Views
- 244
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
The plastic grips broke both on one of the sandwich clamps of our KitchenAid Artisan toaster. So I pulled them/the rest of them off and designed and printed a new one, to not burn our fingers anymore. 😊
Printing Tips
Nothing special to follow here. I printed mine with PETG because it's a bit flexible and more heat resistant. No support is needed. Standard 0.20 layer height setting. I changed the bottom infill layer to be concentric for a nicer look. You may consider printing with a brim.
Assembling Tips
It's designed to be a (very) tight press fit, so no glue is needed, which worked in my case. I pushed it on with my hand as far as I could and then hammer the handle with the grip against a corner of a table - but be careful to do this straight, so it does not break.
Ideas when you have a fitting problem:
- Too tight: try to heat up the metal of the clamp before pressing into the new grip
- Too loose: try to apply some glue, like two-component epoxy stuff
- Both: Simply scale the model up or down a bit