1 / 2
spiggytech 5x2mm magnet fitment test
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is a small gauge I made to test magnet fitting
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 30
- Makes
- 1
- Views
- 241
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a small magnet test for figuring out tolerances. It is what I used to figure out the magnet holes in my AnkerMake bins. You can tilt the tool and add supports to make it print wonky, replicating what it would be like to print a sloped magnet circle.
- blank: 5mm
- one dot: 5.10mm
- two dots: 5.20mm
Designed for Oak @ the M5 community, best regards