Battery Charging/Storage Station

Designed this because I have a bad habit of charging batteries and then setting them off to the side, or in the little cases that come with 18650s, and when it comes time to grab a fresh battery I forget which are charged and which were waiting to go on the charger.

The base is fairly large (250x232x80) and just fits on Bambu Lab print beds. The cutout for the charger is 150L x 116W, so it should fit other chargers aside from the XTAR I designed it around. 

The holes in the honey comb accept inserts that are sized for different batteries. Currently I have inserts included for 18650 (will accept 18500 and 18350), 21700, and 26650. The inserts fit snugly in the holes and don't require gluing. If they do not want to seat, sand off any burr on the bottom edges of the insert.

Clean your print bed thoroughly beforehand and use gluestick, and inner/outer brim for maximum adhesion. 

I would like to remix this at some point to make it more modular and able to be printed in smaller pieces, so if you want a version that can fit on smaller print beds, let me know. I intend to add inserts for other battery sizes as well as accessories, so check back. If you have a request for an insert you want ASAP, let me know.

Printed at 0.16 layer height, 15% infill, no supports (the hole in the back for the charger power cable shouldn't need support, but you can add it if you'd like). 220 degree nozzle, bed temp at or below 60 degrees.