Panthella Style Table Lamp - Supportless

𐌕𐌀𐌁𐌋𐌄 𐌋𐌀𐌌𐌐 𐌉𐌍 𐌔𐌂𐌀𐌍𐌃𐌉𐌍𐌀ᕓ𐌉𐌀𐌍 𐌔𐌕𐌙𐌋𐌄

I redid this one from my old model, now it's easier to print and more stable, the light effect is nicer!

I used this LED lamp
https://www.jula.se/catalog/el-och-belysning/ljuskallor/led-lampor/paronlampor/paronlampa-led-019647/

this is my E14 socket setup https://www.jula.se/catalog/el-och-belysning/elinstallation/lamptillbehor/lamphallare/lampupphangning-410073/

Of course you can use other electronics, but I premade model for this one!

(To pull the cable through the base I used the wire with a needle)

‘Panthella 250’ Designer: ‘Verner Panton’ has nothing to do with my 3d model 

(models only visually similar - they constructed very different) !

Print Settings

• Rafts:No
• Supports:No
• Notes:  ₑₐₛy ₜₒ ₚᵣᵢₙₜ ₙₒ ₛᵤₚₚₒᵣₜ ₒᵣ ᵣₐfₜ ₙₑₑdₑd!
• 5% infill should be enough.