Modern simple hook with invisible mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
As simple as possible, yet very strong
- Rating
- 4.838 / 5
- Likes
- 2,415
- Downloads
- 4,800
- Makes
- 73
- Views
- 26,006
- Reviews
- 68
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE 29/02/2024
Some people requested bigger chamfer on the mount holes to accommodate bigger screw heads.
Original 2mm chamfer
Updated 3mm chamfer
UPDATE 31/01/2024
After first feedback it seems that the original tolerance 0,05mm is too tight for some printers. I found this as a sweet spot after several iterations, but I understand other printers might not allow for such tolerance.
So I am adding hooks with 0,1mm and 0,15mm tolerance. The mount stays the same.
This should be OK for most printers as any bigger tolerance could cause play between mount and hook.
____________________________________________________________________________________________________________
When renovating our hall, we wanted some very simple, yet modern hooks, with possible no visible mounting points / screws. So I came up with this design.
The fit is quite tight, I wanted to have no play, so it might require some dialing.
There are small bumps at the end, so the hook clicks nicely in place:
Print instructions
- 0,1mm layer heigh - or just as low as possible to allow good insertion
- Printed in PLA, but any material should do
- Print front side down - mount side up for best printability and front visible finish
- No supports needed
- 50% infill
- 4 perimeters
Additional hardware needed
- 2x 4x12 screws (or longer)