Cable strain relief replacement for Philips SalonDry Compact
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cable strain relief replacement part for Philips SalonDry Compact 1400W (Model: HP8103/00).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
Cable strain relief replacement part for Philips SalonDry Compact 1400W (Model: HP8103/00).
After years and years of usage, the strain relief's hook broke on our “Philips SalonDry Compact 1400W” hair dryer, so I quickly designed a replacement part.
Usage:
- To disassemble the dryer just unscrew the 2 triangle screws. (Torx bits work on them.)
There are also some plastic clips at the top. - Pull the original strain relief away towards the plug and leave it for now.
- Apply some superglue to one side on the inside.
Be careful not to get glue inside the cable tunnel! - Insert the cable into the tunnel in one side.
The hook should look backwards when assembled. - Place the other side over the cable and align both sides.
- Use zipties or a spring clamp to keep the two sides together until the glue fully dried.
- Insert the fully assembled model into its place inside the handle.
- Assemble the dryer.
- If you're happy with the new strain relief, cut the old one off with a flush cutter.
Note: This is specifically for the model “HP8103/00”, other revisions might have different strain reliefs.
Printing:
Cut the model into two and print them facing down. (See included image.)
I used the following settings:
- Material: TPU
- Infill: 100%
- Layer height: 0.10mm
PETG should probably work as well.
No support or any other special consideration is necessary.