Inlet Cover MMU PTFE Tubes Original Prusa Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cover for the rear inlet hole to pass through the 5 MMU PTFE tube at 45° angle and keep the enclosure sealed
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 123
- Makes
- 3
- Views
- 470
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked the design of the cable inlet cover, especially as by design they help keep the window in place (you loose one pin connection when cutting out that part from the window, making it a little sloppy in this area), but I was missing a variant for the MMU PTFE tubes.
The blank inlet cover was the perfect base for adding 5x ø4,2mm through holes at a 45° angle to eliminate the sharp bend you'd usually have to do with the other available covers, reducing the friction of the filament path and preventing any possible problems with filament feed and retraction there and also keeping the enclosure nicely sealed.
Depending on the filament you're using and your tolerances, you might want to deburr the holes with a 4mm hand drill, to clean up the seams inside the holes that might interfere with the PTFE tube, making the insertion harder than necessary.
- Installation is the same as the original, 1x M3x6 or M3x8 socket head cap screw and 1x M3 square nut per printed cover
- Print in PETG, ABS, ASA
- No supports are needed