Noctua NF-A20 shelf/table mount and ducts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fan mount for shelfs/tables
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 88
- Makes
- 1
- Views
- 607
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Noctua NF-A20 fan duct and table clamp mount
I chose to go for table clamps on this one, bc the A20 fan is heavier than the 120 and 140mm fans. A table stand would be a lot bigger and I dont want to waste filament if I dont have to
The clamp are a bit special as it dont have any threads. The threads are in the bolt and the nut. The bolt is printed flat and is strong. It is a bit tricky to mount, but be patient.
Bolt and nut thread is M24x2. Bolt thickness is 15mm, nut thickness is 5mm.
There are 2 clamp types. Self tapping and for 7mm M4 nuts.
I used tree support for the large holes bc it didnt take that much longer to print. It might be okay without support too
The fan ducts info:
For the first fuct I made the 15 degree angled one and it worked quite good and thought a more narrow duct would work better. 18 hours later I found out it was kinda worse.
So I went back to the shorter one and made different versions.
Some people have OCD and want it to be different, so thats what I made.
If you want it angled a special degree or something, send me a message.
You can also get the duct to be even shorter or longer. My file is parametric so its easy and fast to edit.
I didn't make it for Prusa i3 bed, but was lucky it fits.
Hardware:
Mounting arm left/right to each clamp you need:
2x M4x12
Mounting fan duct to the fan, you need (I use 4 screws):
4-8x M5x8mm+
To power it, use a 12V fan adapter. I havent made a mount for this yet.