Counting matching models…
I had to replace a few shelf brackets in a bathroom cabinet. These would probably work in kitchen cabinets, bookshelves, or entertainment centers. Print instructions Designed in Tinkercad. Printed in PLA.
I've found it very valuable to use this single layer print to test printer alignment and first layer adhesion. It also makes a handy dust cover between prints!
This basic thrust ball bearing was designed for use with 6mm Airsoft BBs, which are cheap and very spherical (5.95mm+/-0.01mm). I purchased 1000 on Amazon for about $3.50 + shipping. The balls travel on a 40mm diameter raceway. The…
This model is designed to mount a 40mm cooling fan to the RPi. It is intended to be used with my Raspberry Pi Stand . This model also allows access to the 40-pin header. Since the board outline and hole pattern has not changed on the RPi,…
I designed this shelf to support a round woozoo fan on a square bedpost (2.25" or 57mm). I was planning to print it flat on the bed up-side-down, but it has a 220mm diameter. To fit it on the 250x210mm Prusa bed, I had to print it at a…
I hoped that an octagonal chain link could be printed without supports because each link would have a flat surface against the bed. This didn't work out for 10mm links (see my 100+ link chain and 1000+ link 10m chain ), so I scaled it up…
Based on my basic thrust ball bearing design, I increased the outer diameter to 200mm, added a top plate with ribs for support, and added hidden clips to secure the top and bottom pieces while still spinning freely! This comes in 3…
I've been wanting to experiment with OpenSCAD. It's a free CAD program that allows you to design objects with code rather than our normal point and click user interfaces. https://openscad.org/ I also thought this would be a good…
Need a place to put a kleenex box in the car so it's within reach and not rolling around on the floor? This box will clip to the pocket on the back of a car seat. I used a higher angle from the clip to the upper edge of the box and…
Similar to my "split radial ball bearing 4-40 x 3/8" but with metric screws, this ball bearing is designed in 4 sections so it could be printed with the raceway of each section facing up for a smooth surface. The ball bearings are…
After learning how to print 10 rows of 10 links with alternating end links to form a continuous chain (see 100+ link chain ), the obvious question is how far can I go? The answer: 34 rows of 36 links with 33 links on alternating ends for…
Yes, it's another cubicle headphone hangar, but this is designed for a 60mm cubicle wall and includes a place to hang the type A USB connector. Feel free to view or copy the original design on onshape: cubicle headphone hangar print…
These are all currently available results.
