Counting matching models…
BETA The printhead brackets supplied at Github allows for pressure fit around the neck. However there is a tiny bit of wiggle in this mount but the Aliexpress version also allows for removal of the neck to expose M2.5 bolt holes. These…
By lazy, it means that you do not need to reprint any existing parts of the CW2 or Stealthburner. This is a plug-and-play mount for the BD bed levelling sensor that integrates with an existing CW2 setup. It weighs ~4.3g and by placing the…
Additional Items 2x Extension leads 3x M16 Cable Glands (see below) 8x M4x6mm screws (optional) 8x M4x6mm nuts (optional) https://www.ebay.com.au/itm/262679718072…
56 plants in less than 2 sq metres. DIY hydroponics NFT (nutrient film technique) Print Settings Printer: Cr10 modified Resolution: 0.25 Infill: 25% Filament: eSun PLA+ Black Notes: Frame 150x25mm treated pine 90mm down pipe Pipe holders…
NOTE: this is in a very beta state. Most times it works well but the odd times throws strange result. I'll look into this in time. 1. Ensure stepper motors are calibrated and X,Y, Z, E motion is exact…
I decided to rebuild an original CR10 for a mate. Added the following - CanBUS - Braces - Stealthburner on linear rails - BD Sensor https://www.printables.com/model/831679-lazy-bd-sensor-adapter-for-stealthburner-voron/comments/1779948 -…
This is a slight mod to the diff-drive-shaft gear coupling to reduce tolerances, chances of shear and glue failure. Kudos to the original design STL file CRAMER Truggy RC 4x4 Full 3D Printed 🚗 ・3D printer design to download・Cults amazing…
m3x15 button bolts w 2 washers & 1 nut, for outer holes m3x40 button bolts w 4 washers & 3 nuts, for center holes Remove rubber feet from SmartPID and align bracket so that protrusions fit where rubber feet were. The PID is designed to…
These are all currently available results.
