Counting matching models…
I recommend printing the parts as oriented in the provided STL files. The mount is designed to fit only the short probe tips, like in the original model. Magnet holes have been removed, and small dimples were added instead. Recommended…
Simple mount for a thermometer. Fit may be slightly loose or slightly tight depending on the specific model, as tolerances between thermometers can vary. The long bridge in my case didn't need supports and printed fine. Recommended Print…
A remix of @Auback_945221 great model. I've made it work with M3x30 SHCS and removed fan grills This is a mount for the BigTreeTech Octopus mainboard cooling. Needs: 4x M3x30 SHCS PETG should be more than enough My print settings: 3…
I made a higher quality texture for Sovol Zero buildplate texture because i didn't like how pixelated the original was
Requires at least 4x M3x10 SHCS and 50cm of LED strip (25 for each side). I connected mine to the always-on 24V on the motherboard, as the standard LED strip MOSFET can’t supply enough power for COB LEDs, making them too dim. .STEP made…
Disclaimer: The Nevermore Micro V4 is a superior choice, it moves significantly more air than the MF Nano using the same fan, and its form factor fits the rear enclosure wall perfectly. I recommend building it instead. This is a remix of…
This is a mount for the BigTreeTech Eddy probe (both types), tailored specifically for the Sovol SV06 Plus. The mount does not utilize the screws supplied with the probe. Instead, it requires: 2x M3x20 (SHCS) or (BHCS) - either type fits…
Mount designed for the Niimbot D110 label printer, made compatible with the Multiboard PushFit system. This version is compatible with the 2021 (i think) model of the D110 (approx. 77 mm length). Check yours before printing. Supports are…
Print from at least PETG preferably ABS/ASA BOM: 2x BHCS M3x6 - to mount Klipper expander 2x M3x8/6 Plastic screws - to attach the print to printer If you have trouble compiling firmware for it, commenting out 2 lines fixed issues that I…
Print it in ASA or ABS. Make sure shrinkage is properly calibrated, as it has pretty tight tolerances for the sensor. It’s attached to the frame with a small piece of VHB tape. I got the idea to relocate it up here from PetschBauer's model.
Print with TPU, mine is printed in Sunlu TPU 95A and fits perfectly It is inspired by this cap: https://www.printables.com/model/723302-honda-crv-2nd-gen-windshield-washer-reservoir-cap although it is not a remix. It was made from…
These are all currently available results.
