Counting matching models…
This tip is designed to press fit on top of the SotaBeams Tactical Mini Antenna Mast. It is designed to accept a plastic carabiner - the kind recommended by KI6NAZ for example. It has reinforcements on the ring for better stability. It is…
This is a low mass guy ring for the SotaBeams Tactical Mini Antenna Mast. This is sized for the 4th segment up, which seems to work well. It's almost chest height. PETG might be warranted for windier/higher stress climates. The fitment…
This is a snap shut case for the QRP Guys EFHW Tuner. The print of the top cover requires supports around the wire wingnut posts. The rest of it should do ok without supports. In fact, it is best to block supports for the divots where the…
This is inspired by @KJ's design. It is a larger holder to accept 0.18" x 1.6" mini chem lights. It has a middle support to better hold the chem light in place. This is a great little holder for illuminating guy lines when operating…
This jig allows one to stand up the Radioddity HF-009 vertical antenna with a simple 1" hole diameter weight plate. It also has a hexagonal hole in the bottom that one can put a ¼"-20 rod connector nut into. This allows one to mount this…
137 MHz antenna ideas have been published on the web for downloading NOAA 15 and other satellite images. Please note: NOAA 15 was recently decommissioned, but METEOR satellites still broadcast on this frequency. I could not find the gang…
This is a simple stand for a wall mounting ring camera that will enable it to stand alone. For example if you wanted to put it on top of a shelf, a building, etc. It does not have mounting holes in the feet. I designed it to use minimal…
This is a monorail foot to go with the FT817 / FT818 rails that were designed by https://www.thingiverse.com/thing:4118033 I prefer this to having individual feet. This rail nicely clears the mic when folded against the radio body. Use M4…
The N0SA keyer is a great keyer for SOTA/POTA activations. In inclement weather, the skeletonized design will allow debris/rain/etc to interact with the contact surfaces. Additionally, depending on the setup, one may feel the heat off the…
This is a bracket that holds the Wago 221-2401 wire connector. This bracket has strain relief holes to connect antenna wire to the bracket without any need for mini carabiners or other hooks, etc. The holes are sized for the popular wire…
This is just the snap on over cap for the channel knob for the Motorola XTS2500 HT radio. This was designed and printed with PETG for heat resistance and durability.
The MFJ-9232 Loop Tuner knobs are criticized for being too small, and not offering enough resolution to properly identify and note the position of the knob. These replacement knobs offer a number of benefits: 1.) The knob bezel is larger…
This simple slack nut for the ends of antenna wire help manage the wire to keep it from tangling, etc. It is sized for the BNTECHGO 18 AWG wire popular for simple qrp antenna construction. This is designed for a PETG print. Your mileage…
This was designed to hold the Waygo 221-2401 Lever Nut. It has a tab under the bridge across the connector to help secure it in place. It has enough clearance that the levers can be raised, but in the closed position, they should fall in…
These are all currently available results.
