Counting matching models…
Simple peice that you can glue or stick with double sided tape at the bottom of a valve index. Unscrew the tracker form the VIVE Pro (Eye) mount, and screw it in place. You may want to fiddle with the angle to get best results. You will…
This item has a little ridge that fits exactly a standard sheet of 4x5 photographic film. These are generally rigid enough where they will lay flat in there. The lip around it is generally smaller than the “dead” unexposed area created by…
This design has only been tested with a Lomograflock 4x5 instant back so far. And as not been used extensively yet. I will not be responsible if an attachment to the rear of your camera falls out…! Since 1949, most cameras 4x5 view camera…
This is a remix of the linked part where I just put roughly the same holes as the Raspberry Pi mount that is part of the Voron 2.4r2 STLs I did it very quickly and dirty via a boolean operation in Blender. I might pocket the recesses for…
Hot shoe cover that replicate the battery door opening tool that was in the original Canon hot shoe cover for the A(E)-1
This is a simple tab I draw in Fusion 360 to hold the rear frame of my bellows for the “ 4x5 large format camera " project from @KevinValverde_323286 The rear standard design has holes for hexnuts and M3 screws that you can use to bolt…
I own a Meopta Flexaret Va camera. This camera takes push on filters. I just have a yellow one and a close up adapters. On my rangefinder camera, I use a Leica Thread Mount Voigtländer Color Skopar 35mm 2.5 lens that takes 39mm filters. I…
This part allows holding the lens board on @KevinValverde_323286's “ 4x5 large format camera ” better. The front standard frame already comes with screws that should clamp on a board. But I found that the slight interference fit this…
The hard drive is a WD Passport ultra, the WD Element has the same general dimensions and should fit. So, My mom like to use her macbook air on an armchair, and also like to keep stuff on an external hard drive because she only has a…
Sometimes, my bowden tube tended to catch on the left side of my printer. I had 2 solution : Don't route the tube between the tom smooth rods on the top of the machine Design a part that prevent this from happening. So, Here is the larger…
The Lamy 2000 fountain pen normally uses a little ring that prevent the nib and feed to push up into the section. I misplaced it while cleaning mine, and before trying to find it again or order one replacement online, I estimated the size…
English description below Ceci est un petit remix de la modification publiée par Petit_Homard_Breton pour la Dagoma DiscoEasy 200 Il s'agit simplement de couper une partie de la fixation de l'axe X (coté moteur) qui empèche la tête du…
Apparently this button is not attached to the camera in any way and will just fall out of the camera when you remove the bottom plate. I recently got this film camera. It had a number of small issues, including this button being missing.…
These are all currently available results.
