Swing out window spacer extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A longer arm that fits in the hole of swing-out window spacers to keep the window cracked at a wider angle.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 99
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
A longer arm that fits in the hole of swing-out window spacers to keep the window cracked at a wider angle.
200, 220 and 230mm lengths (shown in pictures). Best printed in PETG with 4+ walls (or less if you use thicker extrusions) to help with the deflection along the length of the arm. I found that PLA was too stiff for the clip end.
The clip on the end that fits into the swing-out spacer is very tight; expect to use a bit of heat to bend in the fingers on the clip and loosen the fit.
To remove the arm, you'll need to push up from below the clip - trying to lift it up from the end will most likely snap the cylindrical clip off.