Swing out window spacer extension
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A longer arm that fits in the hole of swing-out window spacers to keep the window cracked at a wider angle.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 99
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial
A longer arm that fits in the hole of swing-out window spacers to keep the window cracked at a wider angle.
200, 220 and 230mm lengths (shown in pictures). Best printed in PETG with 4+ walls (or less if you use thicker extrusions) to help with the deflection along the length of the arm. I found that PLA was too stiff for the clip end.
The clip on the end that fits into the swing-out spacer is very tight; expect to use a bit of heat to bend in the fingers on the clip and loosen the fit.
To remove the arm, you'll need to push up from below the clip - trying to lift it up from the end will most likely snap the cylindrical clip off.